Newtec MDM6000 - Device Management Configuration Block; Data Input and Output Interface Configuration

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
29/314
Block Diagram MDM6000 Satellite Modem
9.1 Device Management
This functional block contains all the configuration parameters concerning the management
interfaces.
In this block, it is also possible to configure or look up the following:
• Ethernet connectivity;
• IP connectivity;
• Interface Link Redundancy;
• Device Redundancy;
• Identification of the device;
• Consult all the device options that are activated on the device including the sales code.
9.2 Data Input and Output Interfaces
These Ethernet connectors are bidirectional and are used as input and output interfaces,
transporting IP traffic.
Configure the Ethernet and IP connectivity, including the data gateway IP address of the data
interfaces. Also configure the data interface link redundancy (bonding) in this block.