Newtec MDM6000 - Resetting the MDM6000 Device

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
115/314
General Device Settings and Actions MDM6000 Satellite Modem
12.11 Reset the Device
Resetting the device causes data loss on an active link!
When a user wants to perform a reset using the front panel or CLI, no caution
message is displayed!
The device can be reset when needed.
» Navigate to the Tasks Pane;
» Click Device;
» Click Reset.
Different reset types are possible:
• Hardware: Resets the software and the hardware (=reboot);
• Software: Resets the software;
• Configs: Resets the application specific parameters.
For connectivity reasons, the device specific parameters are excluded from this reset. For more
information please refer to section: ConfigurationFileonpage96 .
• Factory: Resets all parameters to their default values.
This action is only possible via the CLI interface.
A factory reset removes all stored configurations.
All IP settings are reset to their default values, meaning that the device may become
unreachable!