Newtec MDM6000 - Using the Graphical User Interface (GUI)

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
47/314
How to Manage the Device MDM6000 Satellite Modem
11.5 How to Use the Graphical User Interface
The graphical user interface is a web application that gives remote access to the MDM6000. It allows
the user to:
• Manage the device;
• Create or change configurations;
• Monitor the status of the MDM6000 through alarms.
The GUI is optimized for displays with a screen resolution of 1024 x 768 or higher.
11.5.1 Opening the GUI
Proceed as follows to open the GUI on a computer in the network:
» Open a web browser;
It is advised to use Firefox 10 or Google Chrome as standard browser, but the GUI
can also run on other compatible browsers like Internet Explorer 9, Safari …
» Type the IP address of the device in the address bar of the browser. The default IP address is
10.0.0.1/16.
Make sure that the management PC has access to this IP Address or it belongs to this
IP range. If needed it is possible to configure the Mgmt Gateway.
» Press Enter.
The following graphical user interface is displayed.