Newtec MDM6000 - Flexacm in a Point to Point Setup

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
201/314
Feature Descriptions MDM6000 Satellite Modem
14.7.3 FlexACM in a Point to Point Setup
The following figure shows the point-to-point configuration.
Please refer to the Configuration Guidelines for FlexACM between two MDM6000
devices. This document can be found on the CD-ROM that is delivered together with
the device.
To be able to keep the optimal ModCod at all time there must be feedback from the demodulator to
the modulator telling the modulator if another ModCod should be chosen and what that ModCod
should be.
Following applications are handling the FlexACM feature:
• The ACM client at demodulator side;
• The ACM controller at the modulator side.