Newtec MDM6000 - Selecting Demodulation Modes

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
177/314
Feature Descriptions MDM6000 Satellite Modem
The main parameters are:
• Enable;
• Mode;
• Input Frequency;
• Symbol Rate;
• Acquisition Range;
• Roll Off:
• Input Selection;
• Physical Layer Scrambler Signature;
• LNB Power supply
• Transponder Operational Mode
• Spectral Inversion;
• Monitoring parameters;
• ModCod Statistics.
14.6.1 Enable/Disable Demodulator
MDM6000 >> Demodulator >> Enable
Each demodulator can be enabled or disabled by setting the Enable parameter either "off" or "on" for
respectively activating or de-activating the specific demodulator.
14.6.2 Demodulation Mode
MDM6000 >> Demodulator >> Mode
Set the demodulation mode:
• DVB-S2;
• DVB-S2X;
• S2 Extensions.
(To see which modes are available on the device please check the installed device options, refer to
section DeviceIdentificationonpage107).
For more info on DVB-S2, DVB-S2X and S2 extensions please refer to
Appendix-OverviewoftheUsedTechnologiesonpage279