Newtec MDM6000 - Colors Used in the GUI

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
61/314
How to Manage the Device MDM6000 Satellite Modem
11.5.11 Colors Used in the GUI
In the schematic overview, colors are used per functional block to provide the status of the device.
The traffic flow is also indicated between the functional blocks by arrows.
The following colors (LEDs) are used:
• Green : The device is working as expected;
• Yellow warning sign :
– Device Management: Device redundancy is active and the device is in standby mode:
Note: yellow is only used by this functional block.
– Modulator; The build in PRBS generator is active.
• Grey : This functional block is not active in the current configuration.
• Red : An alarm is present on the functional block;
The following colors are used for the process flow arrows:
• Black: Inactive, no data is transported;
• Green: Data is available on this part in the process flow (incoming, outgoing or transfer of data
within the device);
• Red: A problem exists on this part of the process flow.
For example: