Newtec MDM6000 - Configuration of the AUPC Controller; Gather All Block up Converter Specifications

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
207/314
Feature Descriptions MDM6000 Satellite Modem
14.8.5.1 Gather all Block Up Converter Specifications
The BUC specifications should be consulted by the responsible installer to ensure:
• That the BUC is operated with sufficient power backoff to keep the spectral re growth below
required limits;
• That the BUC back-off is sufficient under all temperature conditions.
Acquiring the specifications of the BUC is the full responsibility of the operator!
Also verify the link budget for the uplink noise limited link.
14.8.5.2 Configuration of the AUPC Controller
The following figure shows the AUPC controller and the clear weather conditions that should be
respected during configuration of the AUPC feature.
The following table describes the different AUPC controller parameters.
MDM6000 >> AUPC Controller
Parameter Value Description
AUPC Controller
Enable
On/Off/
Monitoring only
Activate (On)/deactivate (Off) the controller.
Monitoring only, use this setting when you want to
evaluate the feature. AUPC is simulated, next to the
monitoring results the different AUPC logging files can be
consulted.
Nominal Output
Power
Range
-35 - 10 dBm
This value needs to match with the output
level defined under:
MDM6000 >> Modulator >> Output Power
Level
When this is not the case the modem
increases its power when AUPC is
Activated/Deactivated.