Newtec Proprietary
Confidentiality: Unrestricted
V1.0
126/314
General Device Settings and Actions MDM6000 Satellite Modem
12.14 Remote Terminals
In this menu you can define the different remote sites that are used in the system setup.
The following figure shows the use of the terminals in a point to multipoint system setup.
Note that the Terminal Id is defined on the terminating device (remote modem).
Note that it is also required to configure the terminal Id on the HUB site of the system
setup. This to setup the return link between the remote sites and the HUB.
To Next Page
Loading...
