Newtec MDM6000 - Page 122

To Next Page

To Previous Page

Newtec Proprietary

Confidentiality: Unrestricted

V1.0

112/314

General Device Settings and Actions MDM6000 Satellite Modem

When the NTP peer addresses are inserted, time and date of the MDM6000 are updated with the

received information as soon as the MDM6000 can connect to one of the NTP peer servers.

Main Page

Default Chapter2
- Table of Contents2
1 Copyright11
2 EU Compliancy Statements12
- Radio and Telecommunications Terminal Equipment (R&TTE) Directive 1995/5/EC12
- EMC Information13
- Restriction of Hazardous Substances Directive (Rohs) (Directive 2011/65/EU)13
- Registration, Evaluation and Authorization of Chemicals (REACH)14
- WEEE - Waste Electrical and Electronic Equipment Directive15
3 Safety Regulations16
- Environmental18
- Rack Mounting Instructions18
- Earth Ground19
4 Options20
5 Feedback22
6 About this Manual23
- Version History and Applicability23
- Cautions and Symbols23
- Related Documentation24
7 Introduction25
- Efficiency at the Core25
- Optimal Availability25
- Flexibility and Scalability Matching Market Business Models26
8 Physical Description27
- Front Panel Description27
- Back Panel Description31
9 Block Diagram38
- Device Management39
- Data Input and Output Interfaces39
- BBF over IP in40
- Encapsulation41
- Modulator43
  - PRBS Generator43
  - L-Band TX or IF-Band TX Interfaces43
- Demodulator44
  - L-Band RX a / L-Band RX B Input Interfaces44
- BBF over IP out46
- Decapsulation47
10 Getting Started48
- Set the Management IP Address48
- Set Date and Time49
- Configure and Save50
11 How to Manage the Device51
- Management Model / Menu Tree51
- Management Ethernet Interfaces53
- Management IP Connectivity54
- Ethernet Link Redundancy55
- How to Use the Graphical User Interface57
- How to Use the Front Panel76
- Command Line Interface (CLI)83
- Snmp98
  - Consult the SNMP Mibs99
- File Transfer Protocol (FTP)100
12 General Device Settings and Actions102
- Access Control102
- License File103
  - License Upgrade104
- Configuration Settings105
- Software Upgrade115
  - Software Upgrade Procedure115
- Device Identification117
- Logging117
- Diagnostics Report120
- Date and Time121
- Device Monitoring123
- Device Redundancy123
- Reset the Device125
- Alarm Handling126
- Control Plane131
- Remote Terminals136
  - Configure the Terminals137
  - Monitoring138
- Reference Clock139
- Antenna Control Interface140
13 Data Interfaces146
- Data Ethernet Interfaces146
- Data IP Connectivity147
- Data Ethernet Link Redundancy151
- BBF over IP in154
- BBF over IP out158
- L-Band Rx a / L-Band Rx B160
14 Feature Descriptions161
- Modulator161
- DVB Carrier Identification179
- Equalink181
- PRBS Generator183
  - How to Monitor the Outgoing PRBS Bit Rate184
- Reference Clock185
- Demodulator186
- Flexacm206
- Automatic Uplink Power Control212
- Device Redundancy227
- DC BUC Power on L-Band Tx229
- Stream Encapsulation232
- Stream Decapsulation260
- Test Traffic Generator and Monitoring268
  - Test Traffic Generator268
  - Test Traffic Monitoring270
- Transparent BBF over IP272
- In-Band Remote Management274
  - How to Configure the In-Band Management Feature275
    - Hub Site275
    - Remote Site276
  - Example276
    - Configure the Hub Site277
    - Configure the Remote Site280
15 Appendix - Alarm List281
- Generic Alarms282
- Ethernet Interface Alarms283
- BBF over IP Alarms284
- Modulator Alarms285
- Reference Clock Alarms286
- Demodulator Alarms287
- Alarms: BUC Power Alarms288
16 Appendix - Overview of the Used Technologies289
- DVB-S2, DVB-S2X and S2 Extensions289
- Noise and Distortion Estimator (Node)293
  - How Does Node Work293
- Wideband295
- Clean Channel Technology295
17 Appendix - Classification Expressions296
- Example Expressions299
18 Appendix - Generic Stream Encapsulation300
- GSE Header301
19 Appendix - Technical Specifications302
- Input Interfaces302
- Modulation and Demodulation302
- Modulation Interfaces309
- Demodulation Interfaces311
- Internal 10 Mhz Reference Frequency312
- Generic312
- Physical312
20 Appendix - Back Panel Combinations313
- Module 1313
  - Demodulator Input and Modulator Output Interface313
  - Mains Power Supply Units315
- Module 2317
- Example318
21 Appendix - Acronyms319

Newtec MDM6000 - Page 122

Table of Contents

Other manuals for Newtec MDM6000

Related product manuals