Newtec MDM6000 - Page 153

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
143/314
Data Interfaces MDM6000 Satellite Modem
Options Descriptions
Data1 or Data2 (Redundant) The bonding interface is active.
There is no preference in priority between the two available
interfaces.
Data1 before Data2
(Redundant)
The bonding interface is active.
Interface Data1 has priority over interface Data2. This
means that when Data1 is available, this will be the active
interface.
Data2 before Data1
(Redundant)
The bonding interface is active.
Interface Data2 has priority over interface Data1. This
means that when Data2 is available, this will be the active
interface.
To configure the bond interface, refer to section: DataIPConnectivityonpage137.
To have bonding working properly make sure to configure the switch/router in such a
way that the spanning tree is not blocking the fast switchover between ports.
In a typical Cisco switch configured using rapid spanning tree this is achieved by
setting the ports in PortFast mode.