112 Chapter 3 Use the Océ TDS700 flexible scanner
Scale to another media size
Scale to another media size
Introduction
You can use the 'Scale' setting to copy to a larger or smaller media format. Use one
of the following methods to scale a copy.
■ Select another media format with the 'To fit' setting.
■ Adjust a value in terms of percentage with the 'Custom' setting.
You can adjust a value between 25 and 400%. A value lower than 100% reduces
the copy, a value greater than 100% enlarges the copy.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ TDS700 Power Logic
®
controller
application.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the 'Scheduled jobs'
in the Océ TDS700 Power Logic
®
controller application, a scan-to-file job appears
in the selected destination of the 'Scan jobs' workspace.
How to copy to another media size
1. Place the first original face down and right aligned. Make sure that you feed the
original portrait.
The scanner takes the original.
2. Define the job settings.
[59]
[59] Example of a 'Scale' icon
■ Select 'Copy' with the upper-left softkey.
The copy job templates appear.
■ Open a copy job template with a left softkey.
The top 5 settings appear.
■ Scroll to 'Scale' and open this setting with the left softkey.
The 'To fit' and the 'Custom' setting appear.
■ Define the media format at the 'To fit' setting with the scroll wheel.
3. Define the number of copies and press the green start key.
Result
The Océ TDS700 copies to another media size.
To Next Page
Loading...
