Oce TDS700 - Give Priority to Copy Jobs over Print Jobs

82 Chapter 2 Use the Océ TDS700 to print a job
Give priority to copy jobs over print jobs
Give priority to copy jobs over print jobs
Introduction
The tool bar of the 'Scheduled jobs' area allows you to configure the setting that
defines the priority of copy jobs in the list with jobs to be printed. If enabled, this
means that a print job only starts to print if there are no copy jobs in the 'Scheduled
jobs' at that time.
Note: The 'Preferences' workspace also offers you the same function to give priority
to copy jobs over print jobs in the 'Scheduled jobs'.
Purpose
The jobs in the 'Scheduled jobs' are re-arranged to separate the copy jobs from the
print jobs. The copy jobs precede the print jobs in the 'Scheduled jobs'. The jobs are
printed in the order in which they are present in the 'Scheduled jobs'.
Before you begin
Make sure that you have sufficient permissions to perform the action in the
'Preferences' workspace.
■ 'Anonymous' - no permission, only viewing access
■ Repro operator - no permission, only viewing access
■ Key operator - permission, editing is allowed
■ System administrator - no permission, only viewing access
How to give priority to copy jobs over print jobs
1. Click 'Preferences' in the vertical icon toolbar on the left-hand side of the screen.
2. Click 'System defaults' - 'Job management' - 'Copy priority'.
3. Check if the 'Copy priority' to set to On.
Result
All jobs that appear in the 'Scheduled jobs' are sorted into print jobs and copy jobs.
The copy jobs are placed before the print jobs in the 'Scheduled jobs'. Therefore, the
copy jobs get priority over the print jobs.