Oce TDS700 - Image Card Settings; Scale

209
Scale
Image card settings
Scale
Introduction
The ‘Scale’ option allows you to scale while scanning to a file. When you set ‘File
mode’ to ‘On’ then the automatic ‘Scale’ setting will result in ‘1:1’.
You can change this default setting into one of the following three settings.
■ Custom
■ 1:1
■ Scale table
■ Automatic
Custom
This option lets you specify a scale value. You can enter a range from 25% through
400%. This value also shows the scale value when the option ‘Automatic’ is chosen.
1:1
With this option selected, scan to file will result in an image that is exactly the same
size as the original. ‘Scale’ displays 100%.
Scale table
This option lets you select a pre-defined reduction or an enlargement conversion.
Automatic
Selecting ‘Automatic’ always results in a 1:1 scan-to-file.