Oce TDS700 - Océ TDS700 Power Logic controller setup

294 Chapter 8 Accounting software: Océ Account Center
Océ TDS700 Power Logic® controller setup
Océ TDS700 Power Logic
®
controller setup
Introduction
Before you begin to use Océ Account Logic, you must do the following.
■ Activate Océ Account Logic by activating the licence in Océ License Logic.
■ Check the correct settings in the Océ TDS700 Power Logic
®
controller
application. When you have activated Océ Account Logic the relevant settings in
the Océ TDS700 Power Logic
®
controller application will be set to the correct
value.
Before you begin
Before you begin you can check and if necessary modify the correct settings in the
Océ TDS700 Power Logic
®
controller application on the Océ TDS700 Power
Logic
®
controller application, log on as a machine administrator.
Note: Refer to the on-line help of the Océ TDS700 Power Logic
®
controller
application for information about the settings and the location of the settings.
Note: After an upgrade of Oce Account Logic all the administrative settings are
maintained. You can check the settings in the 'Administration' window.