Oce TDS700 - Page 295

295
Océ TDS700 Power Logic® controller setup
The correct settings
[56]
The path to the setting in
the Océ TDS700 Power
Logic
®
controller
application
Definition Explanation
Path: 'Preferences' -
'System defaults' - 'Job
management' - 'Print jobs'
Select 'Always
to Waiting jobs'.
Océ Account Logic requires that
all jobs are sent to the 'Waiting
jobs' area.
Note: The print jobs
that have valid account
information are
automatically moved
from the 'Waiting jobs'
to the 'Scheduled jobs'.
Enter the account
information for the
print jobs that do not
have valid account
information on the
'Print' tab of Océ
Account Logic.
Path: 'Preferences' -
'System defaults' - 'Job
management' - 'Rights for
printing from waiting jobs'
Repro operator
& key operator
only
These users are special users on
the Océ TDS700 Power Logic
®
controller application that have all
rights in the 'Print jobs'
workspace.
Path: 'Preferences' -
'System defaults' -
'Scanner' (productive) -
'Panel time-out'
Path: 'Preferences' -
'System defaults' -
'Scanner' (flexible) - 'Panel
time-out'
Océ advises you
to set the panel
timeout to the
minimum value
(30 seconds).
The scanner locks when the
scanner panel timeout expires.
The scanner locks to prevent users
to use the scanner without
entering account information.
When you set the timeout to a
minimum value, the scanner locks
after a minimum of time has
passed.