178 Chapter 4 Use the Océ TDS700 productive scanner
Settings on the Océ TDS700 scanner operator panel
Correct the settings with the correction key
1. Press the Correction key one time to return to the default value of the active setting.
2. Press the Correction key two times to set the numeric display to 1.
3. Press the Correction key three times to return to the top layer of the scanner operator
panel. When the scanner templates are enabled in the Océ TDS700 Power Logic
®
controller application, the top layer shows the templates. When the templates are not
enabled in the Océ TDS700 Power Logic
®
controller application, the top layer shows
the ‘Custom’ section.
When ‘Automatic feed’ is selected for a single sheet job, this setting stays active
after the job is completed.
Job interrupt only stays active for one job. You have to press the Job interrupt key
before each new job you want to give interrupt priority.
The scanner operator panel will automatically return to the top layer and the default
settings after the time defined in the ‘panel time-out’ setting in the Océ TDS700
Power Logic
®
controller application.
To Next Page
Loading...
