Oce TDS700 - Connect to the controller

240 Chapter 5 Océ TDS700 Power Logic® controller Remote
Connect to the controller
Connect to the controller
Introduction
After you start Océ TDS700 Power Logic
®
controller Remote, you must connect to
the Océ TDS700 Power Logic
®
controller.
You can do the following when you connect to the controller.
■ Select a system from the drop-down list.
■ Add a system to the drop-down list.
■ Remove a system from the drop-down list.
When the Océ TDS700 is not available in the 'Connect to' window, you must add the
Océ TDS700 to the list of available systems.
How to connect to a system
1. Run the application.
2. From the 'File' menu, select 'Connect to'.
3. Select the system from the drop-down list.
4. Click 'OK'.
Note: From the 'Edit' menu, select 'Options' to define the default system. This is
recommended if you frequently connect to the same system.
How to add a system
1. From the 'File' menu, select 'Connect to'.
2. Click 'Edit'.
The 'Edit systems' dialogue box appears.
3. Enter the IP address or the name of the system in the 'Systems' box.
4. Click 'Add'.
The system is added to the list.
5. Click 'OK' 2 times to return to the application.
How to remove a system
1. From the 'File' menu, select 'Connect to'.
2. Click 'Edit'.
The 'Edit systems' dialogue box appears.
3. Select the system you want to remove.
4. Click 'Remove'.
The system is removed from the list.
5. Click 'OK' 2 times to return to the application.