Oce TDS700 - Available settings for copy jobs

101
Available settings for copy jobs
Available settings for copy jobs
Introduction
The Océ TDS700 provides a lot of settings to manage all your different copy jobs.
These settings are used for extended copy jobs. The following table gives an
overview and a very short description of the available settings. This table is not
complete, because a setting can contain more than one setting. You find a detailed
description of each setting in the on-line help of the Océ TDS700 Power Logic
®
controller application. You can change the default value of a setting that you use very
often in the scanner template in Templates workspace of the Océ TDS700 Power
Logic
®
controller application.
Available settings for copy jobs
[14]
[14] The available settings for copy jobs, a setting can contain more than one
setting. (1 – 3)
Setting Function
'Original type' Define the type of original you use
[37]
[37] 'Original type' (example)
'Scale' Scale an original
[38]
[38] 'Scale' (example)
'Media' Define the type of media you use
[39]
[39] 'Media' (example)
'Lighter/darker' Make a lighter or darker copy
[40]
[40] 'Lighter/darker' (example)