376 Chapter 10 Maintain the Océ TDS700
Paper jam in the roll feed section
Paper jam in the roll feed section
Paper jam in the roll feed section
1. Open the appropriate roll drawer.
Note: Only one compartment can be open at a time.
2. Remove any jammed printing material from the paper path and, if necessary, pull
back the paper and rewind it.
Note: Occasionally, a jam may occur before the printing material has been cut. In
that case, you can cut the material manually by pressing the appropriate green load
button in the roll drawer.
3. Reload the roll if the system asks you to do so (see ‘Load rolls of media’ on
page 354).
4. Close the roll drawer again.
Note: If the roll drawers are still highlighted in the illustration on the printer
operator panel, re-check the roll feed section.
To Next Page
Loading...
