Oce TDS700 - Do a Basic Scan-To-File Job

124 Chapter 3 Use the Océ TDS700 flexible scanner
Do a basic scan-to-file job
Do a basic scan-to-file job
Introduction
This section describes a general workflow for a basic scan-to-file job.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ TDS700 Power Logic
®
controller
application.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the 'Scheduled jobs'
in the Océ TDS700 Power Logic
®
controller application, a scan-to-file job appears
in the selected destination of the 'Scan jobs' workspace.
How to do a basic scan-to-file job on the Océ TDS700
1. Place the original face down and right aligned.
The scanner takes the original.
[71]
[71] Place the original face down and right aligned.
2. Select 'Scan-to-file' with the upper-left softkey.
3. Press the green start key.
Result
The scanner scans the original and the sends the scanned file to the default
scan-to-file destination.