Oce TDS700 - Job Management in the Printed Jobs; Re-Print a Job in the Printed Jobs

87
Re-print a job in the 'Printed jobs'
Job management in the 'Printed jobs'
Re-print a job in the 'Printed jobs'
Introduction
You can re-print a job from the 'Printed jobs' without changing the job settings. You
can also change the job settings before you reprint the job. This job is sent to
'Scheduled jobs' and will be printed on the Océ TDS700. The job disappears from
the 'Printed jobs' when it arrives in the 'Scheduled jobs'. If the 'Printed jobs'
destination is enabled the job goes to the 'Printed jobs' after the print process is
completed.
Before you begin
Make sure you have sufficient permissions when you log on to the Océ TDS700
Power Logic
®
controller application.
■ 'Anonymous' - no permission, only viewing access
■ Repro operator - permission, editing and other actions are allowed
■ Key operator - permission, editing and other actions are allowed
■ System administrator - no permission, only viewing access
Note: Use the functions in the 'Waiting jobs' toolbar or right-click when you have
selected the job.
How to print a job from the 'Printed jobs'
1. Click 'Print jobs' in the vertical icon toolbar to access the 'Printed jobs'.
2. Select the job(s) you want to print. You can select more than one job at a time.
3. Click 'Print' to send the job(s) to the 'Scheduled jobs'.
Keep in mind that the original job disappears from the 'Printed jobs' and is sent to the
'Scheduled jobs'.
Result
The selected jobs are now added at the bottom of the 'Scheduled jobs'. If you reprint
the jobs to the 'Scheduled jobs' one at a time, each job is added after the last job. If
you select more than one job, the complete selection is added to the 'Scheduled jobs'
in the same order as shown in the 'Printed jobs'.