Oce TDS700 - Extended copy jobs

99
Do an extended copy job
Extended copy jobs
Do an extended copy job
Introduction
The main steps of an extended copy job are described below.
■ Feed the original.
■ Define the job settings.
■ Press the green start key.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the 'Scan jobs' workspace in the Océ TDS700 Power
Logic
®
controller application.
Using scan templates makes the process of defining job settings much easier,
because you can set a group of pre-defined settings for frequent use.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the 'Scheduled jobs'
of the Océ TDS700 Power Logic
®
controller application, a scan-to-file job appears
in the selected destination of the 'Scan jobs'.
How to copy on the Océ TDS700
1. Place your original face-down, right aligned along the original guide. Keep the
legend at your right hand side.
The scanner takes the original.
[35]
[35] Place the original face down and right aligned