216 Chapter 4 Use the Océ TDS700 productive scanner
Non-standard size originals
Special copy and scan jobs on the Océ
TDS700 productive scanner
Non-standard size originals
The productive scanner of the Océ TDS700 system automatically detects the width
of the inserted original. The Océ TDS700 supports both DIN and ANSI formats. The
Océ TDS700 system uses a memory table that contains all standard width - standard
length combinations to predict the length of the original. The scanner also measures
the real length of each original while it is transferred through the scanner.
Note: If you copy thick, thin or damaged originals or originals in a carrier sheet, it
is recommended to use the output at the rear side of the scanner to ensure correct
delivery (see ‘Deliver originals after scanning’ on page 190).
To Next Page
Loading...
