Oce TDS700 - Start the Océ TDS700 Power Logic Application with Océ TDS700 Power Logic Controller Remote

237
Start the Océ TDS700 Power Logic® application with Océ TDS700 Power Logic
Start the Océ TDS700 Power Logic
®
application with Océ
TDS700 Power Logic controller Remote
Introduction
Use the following 2 methods to start the application with Océ TDS700 Power Logic
controller
®
Remote.
■ Use the programs menu of your operating system.
■ Use a command line parameter.
Use the programs menu to start the Océ Power Logic
®
controller application
1. Select 'Start'.
2. Select 'Programs'.
3. Select TDS700 Power Logic controller application Remote.
The application starts with your default system.
Note: You can select another system than your default system (see ‘Connect to the
controller’ on page 240).
Use command line parameters to start the applications
Six command line parameters are available to facilitate the start of the applications.
■ configfile=<config_file>
Sets the configuration file to use.
■ server=server
Sets the indicated server as the server to connect to.
■ language1=lang
Specifies the first language in combination with the parameter
country1=country .
■ country1=country
Specifies the first language in combination with the parameter
language1=language .
■ language2=lang
Specifies the second language in combination with the parameter
country2=country .
■ country2=country
Specifies the second language in combination with the parameter
language2=language .