Oce TDS700 - Install and start Océ TDS700 Power Logic controller Remote

235
Install Océ TDS700 Power Logic controller Remote on your system
Install and start Océ TDS700 Power
Logic
®
controller Remote
Install Océ TDS700 Power Logic controller Remote on your
system
Introduction
The Océ TDS700 Power Logic controller Remote application can run on all
platforms with Java Virtual Machine. This section describes the installation
procedures for the different types of platforms.
Before you begin
To install Océ TDS700 Power Logic controller Remote on Windows
®
9.x, NT, ME,
XP, or 2000, your system must be at least equipped with a Pentium
®
233 with 32 Mb
RAM.
Note: The file name TDS700PLCRemote, used in the installation procedure below
is an example. It can occur that you need to use another name during the installation
procedure.
Installation procedure for Microsoft
®
Windows
®
platforms
1. Insert the Océ TDS700 Power Logic
®
controller Remote CD-ROM or the Océ Power
Logic
®
controller CD-ROM into the CD-ROM drive of your PC.
2. The installation starts automatically. If it does not start automatically, run Setup.exe.
3. Select the required language in the installation wizard and click 'OK'.
4. Follow the instructions on the screen to complete the installation of Océ TDS700
Power Logic
®
controller Remote.
Note: You can only use Océ TDS700 Power Logic controller Remote when TCP/IP
is enabled on your system. Ask your system administrator for help with the
installation procedure for TCP/IP.