Oce TDS700 - Turn on and off the Océ TDS700

37
Turn on and off the Océ TDS700
Turn on and off the Océ TDS700
Introduction
You can separately turn on and off the Océ TDS700 printer and the Océ TDS700
scanner. The Océ TDS700 Power Logic
®
controller is incorporated in the printer and
is switched on and off separately from the printer. You do not have to use a specific
order in which you turn on and off the Océ TDS700 printer and scanner.
[6]
[6] Power On / off options
Part Description
Productive
scanner /
flexible
scanner
Use the On / off switch at the front underneath the original feed table on the
productive scanner to turn on and off the scanner.
Use the On / Off switch at the front underneath the original feed table on the
flexible scanner to turn on and off the scanner.
Printer Use the On /off switch at the rear of the printer to turn on and off power to
the printer. When you are facing the front side of the printer, the power switch
is located at the left hand side at the rear of the printer.
Note: With this switch you also turn on and off the power for the
climate control function of the printer (see ‘Climate control on the
Océ TDS700’ on page 41). Keep the power turned on to be able
to use the Climate control function. Configure the Sleep mode
setting in the Power logic controller application to ensure
minimal power consumption when the system switches to sleep
mode.
Océ TDS700
Power Logic
®
controller
Use the On / off key at the front of the printer to turn on and off the controller
that is located inside the printer.
When the controlller is on:
Press the key only once and wait 30-60 seconds. The green LED of the key
turns off to indicate that the controller is turned off. Keep the key pressed for
4 seconds to immediately turn off the controller.
When the controller is off:
Press the key only once ot start up the controller. The green LED is turned on
when you press the key.
You can also shut down the controller in the Océ TDS700 Power Logic
®
controller application. Access the System menu in the top toolbar to do so.
Note: Use the power key at the front of the controller when the
controller is not placed in the printer but in a separate console.