113
Make a copy on a cut sheet
Make a copy on a cut sheet
Introduction
You can copy on cut sheet media if the required media type or size is not available
on the media rolls of the printer.
Before you begin
If you must enter the same value for a setting very often, you can set this value as the
default value for that setting in the Océ TDS700 Power Logic
®
controller
application.
After you press the start key, the scanner operator panel always shows the job
number and status of the job. A copy job appears temporarily in the 'Scheduled jobs'
in the Océ TDS700 Power Logic
®
controller application, a scan-to-file job appears
in the selected destination of the 'Scan jobs' workspace.
How to copy on a cut sheet
1. Place the original face down and right aligned.
The scanner takes the original.
2. Define the job settings.
[60]
[60] Example of a 'Size' icon
■ Select 'Copy' with the upper-left softkey.
The copy job templates appear.
■ Open a copy job template with a left softkey.
The top 5 settings appears.
■ Scroll to 'Media' and open this setting with the left softkey.
The 'Feed' setting appears.
■ Define 'Manual' at the 'Feed' setting with the scroll wheel.
The settings 'Size' and 'Type' appear.
■ Select 'Size' with the left softkey and define the 'Size' with the scroll wheel.
■ Select 'Type' with the left softkey and define the 'Type' with the scroll wheel.
3. Define the number of copies if necessary and press the green start key.
4. Place the cut sheet media on the manual feed table of the printer.
Result
The Océ TDS700 copies on a cut sheet.
To Next Page
Loading...
