90 Chapter 2 Use the Océ TDS700 to print a job
Disable the 'Printed jobs'
Disable the 'Printed jobs'
Purpose
You do not want to use the 'Printed jobs'. You do not want to re-print the jobs that are
printed on the Océ TDS700.
Before you begin
Make sure you have sufficient permissions when you log on to the Océ TDS700
Power Logic
®
controller application.
■ 'Anonymous' - no permission, only viewing access
■ Repro operator - no permission, only viewing access
■ Key operator - permission, editing and other actions are allowed
■ System administrator - no permission, only viewing access
How to enable or disable the 'Printed jobs'
1. Click 'Print jobs' in the vertical icon toolbar on the left hand side of the screen.
2. Access the setting 'Enable printed jobs' in the top right-hand corner of the toolbar in
the 'Waiting jobs'.
3. Click Off to deny the printed jobs from the 'Scheduled jobs' access to the 'Printed
jobs'.
4. Click On to allow the printed jobs to be stored in the 'Printed jobs'.
Note: You can also access the 'Printed jobs' setting in the 'Preferences' workspace.
To do so select the 'System defaults' tab, the 'Job management' settings group and
'Enable printed jobs'.
To Next Page
Loading...
