152 Chapter 3 Use the Océ TDS700 flexible scanner
View locally scanned files with Océ View Station® LT
Océ View Station LT
®
View locally scanned files with Océ View Station
®
LT
Introduction
With the use of the software application (Océ View Station
®
LT) you can
automatically view a file after scanning or you can view a locally stored scanned file.
You can configure the settings for Océ View Station
®
LT in such a way that the
scanned file is opened automatically.
Purpose
Check the quality of the scanned file before you print or archive the scanned file.
Before you begin
Make sure you have sufficient permissions when you log on to the Océ TDS700
Power Logic
®
controller application.
■ 'Anonymous' - permission, editing and other actions are allowed
■ Repro operator - permission, editing and other actions are allowed
■ Key operator - permission, editing and other actions are allowed
■ System administrator - permission, editing and other actions are allowed
Note: It is not possible to view scanned files that are stored at a remote location.
You cannot use Océ TDS700 Power Logic controller Remote to view scanned files.
How to view a file automatically after scanning
1. Open the Océ TDS700 Power Logic
®
controller application.
2. Open the 'System' menu and select Autoview.
Result
When you scan to file the next time, Océ View Station
®
LT will start up a secondary
window and show the scanned file. If the autoview function is not enabled you can
use the view button in the Océ TDS700 Power Logic
®
controller application to open
the secondary window manually. The procedure below describes this action in detail.
To Next Page
Loading...
