162 Chapter 3 Use the Océ TDS700 flexible scanner
Add templates
Add templates
Introduction
You can add predefined copy templates to your Matrix Job. These templates are
created in the ‘Copy templates’ tab.
Add templates to your Matrix Job
1. Click ‘Add’ in the ‘Matrix composition’ window. The ‘Select a copy template’
window appears.
2. Select one or several templates to apply to the job (up to 50).
3. Click ‘OK’.
The ‘ Matrix composition’ window now contains the templates selected for the
matrix job. The user may want to make changes to any particular template selected
for this job. This can be done in the edit window.
Modify templates from the Matrix Composition window
1. From the Matrix Composition section, highlight the template to modify. The
settings are displayed.
2. Click the setting to modify. The value of the setting is displayed in the ‘Edit’ field.
3. Change the value.
4. Repeat steps 2 and 3 for every setting to modify.
Note: When editing a template, the change is not permanent. The original settings
for that template are not changed. They are only changed for the Matrix job being
printed at that time.
5. Print the Matrix Job.
To Next Page
Loading...
