Oce TDS700 - Make the settings for the Océ Double Decker (Pro)

340 Chapter 9 The finishing options
How to set the media separation method
Make the settings for the Océ Double
Decker
®
(Pro)
How to set the media separation method
Introduction
You can set one of the following media separation settings in the 'Preferences'
workspace of the Océ TDS700 Power Logic

controller application.
■ 'Separation method'
■ 'Separation sheet selection'
■ 'Separation sheet roll'.
■ 'Separation sheet length'
■ 'Leading strip'
Before you begin
Enable the settings of the Océ Double Decker Pro in the 'Preferences' workspace.
Make sure you log on as key operator to be able to define the settings.
Set the media separation settings
1. Log on as key operator.
2. Access the 'Preferences' workspace on the Océ TDS700 Power Logic

controller
application.
3. Click the 'Finishing (Océ Double Decker Pro)' settings.
4. Select the settings to define the 'Separation method'.
Result
The media separation method is made.