70 Chapter 2 Use the Océ TDS700 to print a job
Use Océ Print Exec® Workgroup Basic to send a print job
Use Océ Print Exec
®
Workgroup Basic to send a print job
Introduction
Océ Print Exec
®
Workgroup Basic is a print job submission application that allows
you to send print jobs to the Océ TDS700 through your web browser. You do not
need to make unnecessary trips to the printer, because you can preview your files,
check the printer status and define your media choice remotely.
Note: For this application a separate Océ Print Exec
®
Workgroup Basic user
manual is available.
When to do
Use Océ Print Exec
®
Workgroup Basic to perform the actions described below.
1. Select and collect the files to print (documents and drawings), in a print job. You can
add a maximum of 100 documents or drawings to a print job.
2. Configure the print job.
You can set the document or drawing settings and the print job settings. You can add
a banner to the print job and add a settings configuration for a print job.
3. Submit the print jobs to the 'Scheduled jobs' or the 'Waiting jobs' in the Océ TDS700
Power Logic
®
controller application.
4. Check the print job and the printer configuration status.
You can view the status information of the printer configuration and the available
media.
How to create a job in Océ Print Exec
®
Workgroup Basic
1. From the 'Composition' tab, enter the job name.
2. Specify the number of copies you want to print. You must enter a number in this
field. Default is one copy.
Note: The maximum number of copies at job level may vary when 'Banner' is
selected and 'Collate' is off. The reason why is that the number of copies at job level
multiplied by the number of copies at document level cannot exceed 999.
3. Define the job settings.
Note: To set the options 'Ignore documents headers' or 'Send to waiting jobs queue',
go to the 'Preferences' menu.
To Next Page
Loading...
