54 Chapter 2 Use the Océ TDS700 to print a job
Special media indication
Special media indication
Introduction
On the Océ TDS700 printer, you can attach a special indication (exclamation mark
(!)) to a roll or sheet feeder which uses special media (for instance coloured paper).
This indication is used to identify the roll or sheet feeder to the printer. For this roll
or sheet feeder the automatic media change option is disabled.
Set a special media indication
1. Press the on-line key on the printer operator panel to put the printer off-line. The
message Off-line is displayed in the status window.
2. Press the left selection key to shift the focus to the Media option. A shadow effect
is used to indicate that the focus is set to this option.
3. Use the Up / down keys to select the roll or sheet feeder for which you have just
loaded special media.
4. Press the right selection key to activate the Type option. The dotted line around the
current selection is changed into an uninterrupted line and the small selection
triangles next to the specified type are no longer dimmed.
5. Use the Up / down keys to select the Special option for the specified roll or sheet
feeder.
6. Press the on-line key to put the printer on-line again. The printer now knows that the
specified roll or sheet feeder contains special material.
To Next Page
Loading...
