Oce TDS700 - Page 53

53
Media type and size on the printer
Set media type for manual feed
1. Press the on-line key on the printer operator panel to put the printer off-line. The
message Off-line is displayed in the status window.
2. Press the left selection key to shift the focus to the Media option. A shadow effect
is used to indicate that the focus is set to this option.
3. Use the Up / down keys to select the Manual option.
4. Press the right selection key to activate the Mat. (Material) option. The dotted line
around the current selection is changed into an uninterrupted line and the small
selection triangles next to the specified material are no longer dimmed.
5. Use the Up / down keys to select the material you just loaded.
6. Press the on-line key to put the printer on-line again. The printer now knows which
material is used by the manual feeder.
Set media size
1. Press the on-line key on the printer operator panel to put the printer off-line. The
message Off-line is displayed in the status window.
2. Press the left selection key to shift the focus to the Media option. A shadow effect
is used to indicate that the focus is set to this option.
3. Use the Up / down keys to select the roll or sheet feeder for which you have just
loaded new media.
4. Press the right selection key to activate the Size option. The dotted line around the
current selection is changed into an uninterrupted line and the small selection
triangles next to the specified size are no longer dimmed.
5. Use the Up / down keys to select the size for the media you just loaded. The printer
shows both DIN and ANSI sizes. Select a size from the correct format.
6. Press the on-line key to put the printer on-line again. The printer now knows which
media size is used for the specified roll or sheet feeder.