Oce TDS700 - How to Set the Tray Selection Method

341
How to set the tray selection method
How to set the tray selection method
Introduction
You can set one of the following tray selection settings in the 'Preferences'
workspace of the Océ TDS700 Power Logic

controller application.
■ 'Tray selection method'
■ 'Job type delivery'
■ 'Switch tray on set size'
■ 'Switch tray for each set'
■ 'Select on media size'
Before you begin
Enable the settings of the Océ Double Decker Pro in the 'Preferences' workspace.
Make sure you log on as key operator to be able to define the settings.
Set the tray selection setting
1. Switch the tray selection lever to the middle position.
2. Log on as key operator.
3. Access the 'Preferences' workspace on the Océ TDS700 Power Logic

controller
application.
4. Click the 'Finishing (Océ Double Decker Pro)' settings.
5. Select the settings to define the 'Tray selection method'.
Result
The tray selection method is made.