Oce TDS700 - The reinforcement unit

313
The reinforcement unit
The reinforcement unit
Introduction
If you install a reinforcement unit, output can be delivered with a pre-punched,
self-adhesive strip, see the illustration below.
[170]
[170] Example of a reinforcement unit
With this strip the copy can be stored in a binder, without running the risk that the
punching holes tear out. You can unfold a folded map in a binder without opening
the binder mechanism, see figure below.
[171]
[171] Example of a folded map
The optional reinforcement unit supports all media sizes larger than A4.
(see ‘Clean the reinforcement knives’ on page 330) for more information about
inserting a new tape roll and other maintenance issues.
Note: Reinforcement is only possible with the Standard folding method.