Oce TDS700 - Page 314

314 Chapter 9 The finishing options
The reinforcement unit
Enable reinforcement
1. Access the Océ TDS700 Power Logic
®
controller application.
2. Log on as key operator or repro operator.
3. Click 'Preferences' - 'Print job defaults' - 'Finishing' - 'Binding strip'
4. Select reinforcement to enable the reinforcement option.
Note: You can also set reinforcement on the printer operator panel in the off-line
mode.
Set reinforcement for the copy job in the scanner operator panel of the flexible
scanner
1. Access the Copy templates.
2. Open the ‘Binding’ option in the template.
3. Select ‘Reinforce’.
Set reinforcement for the copy job in the scanner operator panel of the
productive scanner
1. Press the ‘Finishing’ card in the ‘Print’ section.
2. Press the function key ‘Binding’.
3. Select ‘Reinforce’.