Oce TDS700 - No Reinforcement Strips on the Output

334 Chapter 9 The finishing options
No reinforcement strips on the output
No reinforcement strips on the output
Introduction
When there is no reinforcement strip on the output, then
■ The reinforcement strip is not correctly installed, or
■ The reinforcement strip is not available.
Install a new reinforcement strip
1. Press the On-line key on the operator panel to put the printer off-line.
2. Open the side door of the reinforcement unit.
3. Check for loose reinforcement strips in the unit with the protection sheet on (see
situation B in figure 118).
[209]
[209] Situation A: No mechanical error. Situation B: Mechanical error.
4.
If there are, remove the tape strips in the reinforcement unit.
[210]
[210] Removing the tape