330 Chapter 9 The finishing options
Clean the reinforcement knives
Clean the reinforcement knives
Introduction
The knives of the reinforcement unit get sticky from the glue on the reinforcement
tape. You must clean the knives regularly. If you clean the reinforcement knives, you
must put the knives in such a position that you have access to all the parts.
You are recommended to clean the knives when:
■ You install a new tape roll (see ‘Insert a new tape roll’ on page 323) or
■ When an error in the reinforcement unit has occurred.
Attention: Only use the original Cleaner K and Fixing Unit Cleaning Oil
(silicon oil) from Océ, to prevent damage to the reinforcement unit.
Clean the reinforcement knives
1. Press the 'On-line' key on the printer operator panel to put the printer off-line.
2. Select ‘Folding’ with the left selection key.
3. Press the down key to enter the ‘Folding’ menu.
4. Select ‘Clean knife’ with the left or right key.
Note: When a job is running, the message ‘Job interrupted’ appears. The machine
stops running after it has correctly finished the prints that were already printing.
The focus can now be set to the Folding menu. A picture of the printer appears on
the display with the side door of the reinforcement unit blinking.
5. Press the down key to put the reinforcement unit knives in the correct position.
6. Open the side door of the reinforcement unit.
7. Clean the upper and lower knife using Cleaner K.
[203]
[203] Cleaning the upper and lower knife
To Next Page
Loading...
