151
How to retrieve scanned files via FTP
Retrieve files via an FTP command line prompt
1. Launch an FTP client.
2. Enter the ‘FTP’ command.
A DOS box now appears with the FTP prompt.
3. Enter the ‘Open’ command followed by either the registered name of the Océ Power
Logic
®
controller or the IP address (for example: 194.2.66.146) to connect to the
controller and press Enter: ‘open 194.2.66.146’.
The connection with the controller is now established and a window appears asking
you for a user name.
4. Enter your user name ‘Anonymous’, and enter as your password also ‘Anonymous’.
A connection is now set up for the default user ‘Anonymous’.
5. Set the transmission mode to binary by entering ‘Binary’.
6. Go to the ‘Tempstore’ directory using the following command: ‘cd tempstore’.
7. Go to the ‘Scan’ directory if you want to retrieve a file from a destination on the
local host,
or
go to the ‘Unsent’ directory if you want to retrieve a file from ‘Unsent’ folder on
the local host.
8. Get the data file (for example: bugatti.tif) via the ‘Get’ command.
9. Quit FTP by entering the ‘bye’ command.
To Next Page
Loading...
