Omron SYSDRIVE MX2 SERIES - Multi-Step Speed Operation Function (CF1 to CF4, SF1 to SF7); RUN Permission Signal

5-63
5-6 Operation Functions
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-Axxxx)
5
Functions
RUN Permission Signal
A RUN command is accepted only while the RUN permission signal is ON.
To use this function, allocate "84: ROK" to the multi-function input terminal.
Multi-step Speed Operation Function (CF1 to CF4, SF1 to SF7)
Multiple RUN speeds can be set in parameters and the applicable speed can be switched
using the terminals.
For multi-step speed operation, either 4-terminal binary operation (with maximum 16 steps) or
7-terminal bit operation (with maximum 8 steps) can be selected.
Parameter
No.
Function name Data
Default
setting
Unit
C001 to C007
Multi-function
Input Selection
84: ROK (Permission of RUN
command)
−−
Output frequency
ROK input
RUN command
FW, RV input
Parameter
No.
Function name Data
Default
setting
Unit
A019
Multi-step Speed
Selection
00
4-terminal binary operation with up to
16 variable steps
00 −
01
7-terminal bit operation with up to 8
variable steps
A020
Multi-step Speed 1
Reference 0
0.00, starting frequency to maximum
frequency
6.00 Hz
A021 to A035
Multi-step Speed
References 1 to 15
0.00, starting frequency to maximum
frequency
0.00 Hz
A220
Multi-step Speed 2
Reference 0
0.00, starting frequency to maximum
frequency
6.00 Hz
C001 to C007
Multi-function Input
Selection
02 to 05
Binary operation, 16 steps (CF1 to
CF4)
−−
32 to 38
Bit operation, 8 steps (SF1 to SF7)
C169
Multi-step Speed/
Position
Determination Time
0. to 200. (× 10 ms)
Wait time until determination of
terminal input
0. ms