Omron SYSDRIVE MX2 SERIES - Other Displays

7-8
7-1 Error Display and Remedial Actions
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-Axxxx)
7
Maintenance Operations
Other Displays
Name Description Display on Digital Operator
Reset This warning appears if the input terminal set
to Reset (RS) is ON or a trip has been reset
using the STOP/RESET key.
Turns.
Undervoltage standby Appears in undervoltage standby condition or
with the power shut off.
Restart during
momentary power
interruption, restart
during trip
Restart function is in operation.
RUN command is
limited
Appears if the limited RUN command is
received from the control terminal while the
RUN direction is limited with b035.
Setting initialization Appears while the set values are being
initialized.
[ 00]: Setting for Japan
Fault monitor being
initialized
Appears while the fault monitor is being
initialized.
No data Appears when no applicable data is available
(a trip has not yet occurred in the fault
monitor mode).
Communications error Appears if an error occurs between the
Remote Operator and the Inverter.
Flashes.
Auto-tuning OK Appears upon successful completion of
auto-tuning.
Auto-tuning NG Appears upon failure of auto-tuning.
xkxkxkx
-k-k-k-
okokoko
OkOkOkO
0k0
hkc
_k_k_k_
=k=k=k=
_k_k_ko
_k_k_kz