Omron SYSDRIVE MX2 SERIES User Manual

INDEX-3
INDEX
I
Reset .................................................................... 5-100
Reverse rotation prevention function.................... 5-156
RNT ...................................................................... 5-124
Rotation direction limit selection............................. 5-23
Rotation direction monitor......................................... 5-2
RP............................................................................. 2-9
RS......................................................................... 5-100
RUN...................................................................... 5-121
RUN command selection........................................ 5-22
RUN command source......................................... 5-133
RUN direction selection.......................................... 5-23
RUN permission signal........................................... 5-63
RUN time over...................................................... 5-124
RV........................................................................... 5-22
RVR...................................................................... 5-131
S
Safety function...................................................... 5-167
Safety function selector switch ..................... 2-5, 5-167
SC............................................................................. 2-7
Selection of operation on digital operator disconnection .. 5-86
Sensorless vector control ..................................... 5-144
SET......................................................................... 5-54
SETM.................................................................... 5-134
SF1 to SF7 ............................................................. 5-63
SFT......................................................................... 5-84
Signal during forward operation............................ 5-130
Signal during reverse operation............................ 5-131
Signal during RUN................................................ 5-121
Simple position control mode ............................... 5-159
Sink logic ................................................................ 2-19
Soft lock function .................................................... 5-84
Source logic............................................................ 2-19
Speed/position switching function ........................ 5-164
STA......................................................................... 5-56
Stabilization parameter........................................... 5-81
Start frequency....................................................... 5-40
Start ratio................................................................ 5-40
Start selection......................................................... 5-40
User selection......................................................... 5-88
Starting contact signal .......................................... 5-128
Starting frequency .................................................. 5-57
STOP key selection................................................ 5-84
Stop selection......................................................... 5-24
STP......................................................................... 5-56
T
Test Run................................................................. 3-10
TH................................................................. 2-8, 5-120
Thermal warning................................................... 5-113
Thermistor trip function......................................... 5-120
Torque bias function............................................. 5-155
Torque bias monitor.................................................. 5-6
Torque boost .......................................................... 5-49
Torque control ...................................................... 5-155
Torque LADSTOP function................................... 5-154
Torque limit function ............................................. 5-153
Torque monitor function........................................ 5-151
Torque reference monitor......................................... 5-5
Total RUN time......................................................... 5-8
Trip ................................................................. 3-12, 7-1
TRQ...................................................................... 5-153
U
UDC........................................................................ 5-71
Undertorque.......................................................... 5-152
UP........................................................................... 5-71
User parameter automatic setting function........... 5-174
User parameter manual setting function............... 5-174
User selection monitor............................................ 5-10
USP ...................................................................... 5-105
UV........................................................................... 5-97
V
V/f control with speed feedback.............................. 5-83
W
WAC ..................................................................... 5-126
WAF...................................................................... 5-127
Warning .................................................................... 7-6
Warning monitor ..................................................... 5-11
WCFI .................................................................... 5-132
WCFV................................................................... 5-132
Window comparator.............................................. 5-132
Wiring the main circuit terminals............................. 2-10
Z
Zero return function .............................................. 5-165
ZS......................................................................... 5-125

Omron SYSDRIVE MX2 SERIES Specifications

General

Brand	Omron
Model	SYSDRIVE MX2 SERIES
Category	Inverter
Language	English