Omron SYSDRIVE MX2 SERIES - Page 48

2-21
2-2 Wiring
SYSDRIVE MX2 Series USER'S MANUAL (3G3MX2-Axxxx)
2
Design
Wiring Method
1. Use a slotted screwdriver (width: 2.5 mm or less) to push in the orange part of the
control circuit terminal block. (The wire insertion part opens.)
2. With the slotted screwdriver pushed in, insert the wire or ferrule in the wire insertion
part (round hole).
3. Pull out the slotted screwdriver, and the wire will be fixed.
Note: When pulling out a wire, do so by also pushing in the part denoted by with a slotted screwdriver.
Use a slotted screwdriver
to push in the part.
Insert the wire. Pull out the slotted
screwdriver, and
the wire will be fixed.
2.5 mm