Oracle X7-2 Service Manual

Servicing PCIe Cards (CRU)
This section describes how to service PCIe cards. PCIe cards are customer-replaceable units
(CRUs) that require you to power off the server. For more information about CRUs, see
“Illustrated Parts Breakdown” on page 19 and “Customer-Replaceable Units” on page 21.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the components to fail. To avoid
damage, ensure that you follow antistatic practices as described in “Electrostatic Discharge
Safety” on page 50.
Caution - Ensure that all power is removed from the server before removing or installing
PCIe cards. You must disconnect all power cables from the system before performing these
procedures.
Note - For a complete list of supported PCIe cards, refer to the Oracle Server X7-2 Product
Notes at http://www.oracle.com/goto/x7-2/docs.
This section covers the following topics and procedures:
■
“PCIe Slot Characteristics” on page 122
■
“Remove a PCIe Card From PCIe Slot 1 or 2” on page 122
■
“Install a PCIe Card in PCIe Slot 1 or 2” on page 123
■
“Remove a PCIe Card From PCIe Slot 3” on page 124
■
“Install a PCIe Card in PCIe Slot 3” on page 125
Related Information
■
“Servicing PCIe Risers (CRU)” on page 111
Servicing PCIe Cards (CRU) 121

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies