BIOS Advanced Menu Selections
■
“BIOS Advanced Menu PCH SATA Configuration Options” on page 269
■
“BIOS Advanced Menu Processor Configuration Options” on page 271
■
“BIOS Advanced Menu Memory Configuration Options” on page 272
■
“BIOS Advanced Menu CPU Power Management Configuration Options” on page 272
■
“BIOS Advanced Menu USB Ports Options” on page 273
■
“BIOS Advanced Menu Error Injection Settings Option” on page 273
■
“BIOS Advanced Menu Disk Freeze Lock Settings Option” on page 274
BIOS Advanced Menu iSCSI Configuration
Options
The following table lists the BIOS Advance Menu iSCSI Configuration options.
Setup Options Options Defaults Description
iSCSI Initiator Name NA (must be specified) None The worldwide unique name of
the iSCSI Initiator. Only IQN
format is accepted.
Add an Attempt
iSCSI Attempt Name NA (must be specified) None The human-readable name that
you assigned to this attempt.
iSCSI Mode Disabled/Enabled/Enabled for
MPIO
Disabled Set to Enabled for multipath I/
O (MPIO). MPIO can boost the
performance of an application
by load-balancing traffic across
multiple ports.
Internet Protocol IP4/IP6/Autoconfigure IP4 Can be set to IP4, IP6, or
Autoconfigure. The initiator
IP address is assigned by the
system to IP6. In Autoconfigure
mode, the iSCSI driver attempts
to connect to the iSCSI target
using the IPv4 stack. If this fails,
then the iSCSI driver attempt to
connect using the IPv6 stack.
Connection Retry Count 0 to 16 0 The count range is 0 to 16. If set
to 0, there are no retries.
Connection Establishing
Timeout
NA 1,000 The timeout value in
milliseconds. The minimum
value is 100 milliseconds and
the maximum is 20 seconds.
Configure ISID Derived from the MAC address The default value is derived
from the Mac Address
The OUI-format ISID is 6 bytes.
The default value is derived
BIOS Setup Utility Menu Options 259
To Next Page
Loading...
Need help?
General
