Oracle X7-2 Service Manual

BIOS Boot Menu Selections
Setup Options Options Defaults Description
PCI-E UEFI Driver Enable Disabled/Enabled Enabled Enable or disable PCI-E UEFI
Driver. If set to enabled, UEFI
Driver for the card executes as
normal. If set to disabled, UEFI
Driver for the card is not copied
into memory and the execution
of the UEFI Driver is inhibited.
Slot 2, Slot 3, and Slot 4 See Slot 1 description.
BIOS IO Menu PCIE Hardware Slot Configuration
Options
The following table describes the BIOS IO Menu hardware slot configuration options.
Setup Options Options Defaults Description
Slot 1 Hardware
Configuration
Displays and provides options to
configure Hot-plug functionality
or FM10K Bifurcation for the
PCIe HBA slot.
PCIE Slot Hardware
Configuration
HotPlug Disabled/
HotPlug Enabled/
FM_10_8x8_Bifurcation
HotPlug Disabled Enable or disable Hot-plug or
FM10K Bifurcation.
Slot 2, Slot 3, and Slot 4 See Slot 1 description.
Related Information
■
“BIOS Main Menu Selections” on page 253
■
“BIOS Advanced Menu Selections” on page 258
■
“BIOS Boot Menu Selections” on page 278
■
“BIOS Exit Menu Selections” on page 280
BIOS Boot Menu Selections
This section includes a screen of the BIOS Boot Menu. The options that are available from the
Boot Menu are described in the table that follows.
278 Oracle Server X7-2 Service Manual • October 2017

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies