Oracle X7-2 Service Manual

Servicing the Internal HBA Card and HBA Super
Capacitor (FRU)
The following section describes how to service and install the Oracle Storage 12 Gb SAS PCIe
RAID HBA, Internal card and HBA super capacitor. The internal HBA card and HBA super
capacitor are field-replaceable units (FRUs). For more information about FRUs, see “Illustrated
Parts Breakdown” on page 19 and “Field-Replaceable Units” on page 22.
For more information about the internal HBA card, refer to the Oracle Storage 12 Gb SAS PCIe
RAID HBA Internal: 16 Port and 2 GB Memory Installation Guide For HBA Model 7116970 at
http://docs.oracle.com/cd/E87591_01/index.html.
Caution - Ensure that all power is removed from the server before removing or installing the
internal HBA card and super capacitor. You must disconnect all power cables from the system
before performing these procedures.
Caution - These procedures require that you handle components that are sensitive to
electrostatic discharge. This sensitivity can cause the components to fail. To avoid
damage, ensure that you follow antistatic practices as described in “Electrostatic Discharge
Safety” on page 50.
Caution - The internal HBA card and HBA super capacitor should be removed and replaced
only by authorized Oracle Service personnel.
This section covers the following procedures:
■
“Remove the Internal HBA Card and HBA Super Capacitor” on page 170
■
“Install the Internal HBA Card and HBA Super Capacitor” on page 173
Related Information
■
“Disconnect Cables From the Server” on page 58
Servicing the Internal HBA Card and HBA Super Capacitor (FRU) 169

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies