Oracle X7-2 - Servicing the Temperature Sensor (FRU); Remove the Temperature Sensor

Servicing the Temperature Sensor (FRU)
The following section describes how to service the temperature sensor. The temperature sensor
is a field-replaceable unit (FRU). For more information about FRUs, see “Illustrated Parts
Breakdown” on page 19 and “Field-Replaceable Units” on page 22.
Caution - Ensure that all power is removed from the server before removing or installing the
temperature sensor. You must disconnect the power cables before performing this procedure.
Caution - The temperature sensor should be removed and replaced only by authorized Oracle
Service personnel.
This section covers the following procedures:
■
“Remove the Temperature Sensor” on page 163
■
“Install the Temperature Sensor” on page 166
Related Information
■
“Disconnect Cables From the Server” on page 58
■
“Remove the Server From the Rack” on page 61
■
“Take Antistatic Measures” on page 61
Remove the Temperature Sensor
1.
Prepare the server for service.
a.
Power off the server and disconnect the power cords from the power
supplies.
See “Powering Down the Server” on page 53.
Servicing the Temperature Sensor (FRU) 163