Oracle X7-2 Service Manual

Select a Temporary Boot Device
■
“BIOS Setup Utility Menus” on page 224
■
“BIOS Key Mappings” on page 224
■
“Exit BIOS Setup Utility” on page 251
Select a Temporary Boot Device
The Boot Options Priority list displays the boot device candidates for the system.
In addition to using the F2 key to view or edit the system BIOS settings, you can use the F8
key during the BIOS startup to specify a temporary boot device. This selected boot device is in
effect only for the current system boot. The permanent boot device specified using the F2 key
will be in effect after booting from the temporary boot device.
1.
Reset or power on the server.
For example, to reset the server:
■
From the local server, press the On/Standby button on the front panel of the server to
power off the server, and then press the On/Standby button again to power on the server.
■
From the Oracle ILOM web interface, click Host Management → Power Control and
select Reset from the Select Action list. Click Save, and then click OK
■
From the Oracle ILOM CLI, type reset /System
2.
After the server resets, press the F8 key (or Ctrl+P from a serial connection)
when prompted while the UEFI BIOS is running the power-on self-test (POST).
Setting Up BIOS Configuration Parameters 231

Oracle X7-2 Specifications

General

Processor	Intel Xeon Scalable processors
Number of Processors	1 or 2
Memory	Up to 1.5 TB DDR4
Memory Slots	24 DIMM slots
Form Factor	2U Rackmount
Storage Bays	8 x 2.5-inch
CPU Socket	Socket P (LGA 3647)
Power Supply	Redundant hot-swappable power supplies